Day 162
Day 163

Continuous thread needle case

I don't know about you but there are times I get sick of continuously threading needles.  Like, when I am tacking a quilt or sewing paper piecing shapes by hand.  Then I saw some one with a continuous thread needle case and had to design one for myself.  I'm not sure what dimensions theirs was but I wanted one just to hold the thread and another that I could have the thread and a thimble.  So this is my take on the one I saw.

IMG_0081

I have made mine from scraps of fabric and wadding together with old buttons for trim and some left over ribbon for the closure.  If you were going to buy the fabric a couple of fat 1/8ths would get you 2 needle cases.  I think I prefer the smaller version and this is the pattern included. For the wider version just make the pattern 1" (3cm) wider and if you think you want more then 10 needles extend the length.

You can down load Download Needle and Cotton holder with the free pattern here.

I used a main fabric and a contrast for the suffolk puffs.   I also used 45mm Clover puff maker, but I have included a pattern for this if you don't have one.  If you haven't used one of these tools there are lots of videos on You Tube to show you how but personally I have given up sewing puffs by hand the tool is just so quick and easy and every puff is the same as the one before and after it.  This is a link to a tutorial by Pat Sloan.  

So, I cut out my puffs, pulled them up, sewed the button in place in the middle and set them aside.

P1040249

When making the tounge, on the inner facing piece I took my piece of flannel, with the edges pinked and stitched it into position using a straight stitch on my machine.

P1040254

With my main fabric and lining, right sides together, and the wadding behind this, I stitched a 1/4" seam around the edge leaving an opening to turn the fabric through to the right side after trimming back the fabric. I then turned it through, and ironed it flat.  (very important, the ironing.)

Now I find that I like to add my ribbon into the seam after I have turned the fabric through.  This mean I have to undo a few stitches in the middle of the curved end and push my ribbon into position.  Then I stitch close to the edge all the way around.  This closes the turn through opening and attaches the ribbon.

P1040255

Now it is time for hand stitching those puffs into position.  You want the button on the outside. Start at the straight edge corner of your tongue and any position on the puff and over sew the two edges together leaving enough of the puff un-sewn to allow you to put your cotton into the space created.  This will change according to the size of the cotton reel you are using.

P1040253

On the second case I sewed the puff on the inside of the tongue picking up fabric from the puff and the inside of the tongue.

P1040256

I found that this gave a neater finish but this is purely a personal preference.

IMG_0082

Now thread up your needles with your cotton, do not cut the cotton, just thread all the needles continuously.  Now you are ready to go.  Take your needle and pull the cotton through to the length required before cutting the thread.  Continue like this with each needle and then start again.

IMG_0086

These are very quick and cheap to construct and would make a great gift for a sewing friend and think of all the scraps you could use.

Comments

Feed You can follow this conversation by subscribing to the comment feed for this post.

Carolyn Foley


They sure are handy.

Carin Saga

Great idea! The tutorial and the illustrations are, as always on your blog, excellent!

Carolyn Foley


Thanks Carin. I have some more tutorials up my sleeve for the future.

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Working...
Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.

Working...

Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)